Skip to content

Setup & Fixes2 min read

How to install and activate an eSIM on iPhone

Installing a travel eSIM on an iPhone takes about two minutes. Here are the exact steps, the two settings that matter, and what to do if data does not start.

By eSIM Air Editorial

Key takeaways

  • Install at home on Wi-Fi, before you travel — a QR code can only be installed once.
  • iPhone XS, XR and later support eSIM, as long as the phone is carrier-unlocked.
  • After landing: set mobile data to the eSIM and turn on data roaming for that line.
  • No data? Nine times out of ten it is the data roaming switch on the eSIM line.

An eSIM is a SIM card built into your iPhone. Instead of swapping plastic, you scan a QR code and the plan is added as a second line. Your normal SIM keeps working for calls and messages.

Before you start

  • Check compatibility. iPhone XS, XS Max, XR and every later model support eSIM. Go to Settings → General → About: if you see an EID number, your phone has eSIM.
  • Check the phone is unlocked. In the same screen, Carrier Lock should read "No SIM restrictions".
  • Be on Wi-Fi. The phone downloads the eSIM profile over the internet.
  • Have the QR code on another screen — a laptop, tablet or a printed copy. You can also use the one-tap install button in your delivery email or under My eSIMs.

Install the eSIM

  1. Open Settings → Mobile Service (or Cellular) and tap Add eSIM.
  2. Choose Use QR Code and point the camera at the code we emailed you.
  3. Tap Continue, then Done when the plan has been added.
  4. Give the line a label such as "Travel" so it is easy to recognise.
  5. When asked for defaults: keep your primary line for calls and messages, and choose the travel line for mobile data.

When you land

  1. Go to Settings → Mobile Service → Mobile Data and select the travel eSIM.
  2. Tap the travel eSIM line and switch Data Roaming on. This is expected for travel eSIMs and does not add charges.
  3. On your home line, make sure Data Roaming is off so your carrier cannot bill you.
  4. Wait up to a minute for the phone to register on a local network.

If data does not work

  1. Confirm data roaming is on for the eSIM line — this is the cause in most cases.
  2. Toggle Airplane Mode on for ten seconds, then off.
  3. Check that mobile data is set to the eSIM, not your home line.
  4. Restart the phone.
  5. In Mobile Service → Network Selection, turn Automatic off and pick another listed network.

Still stuck? Do not delete the eSIM — a deleted profile usually cannot be reinstalled. Contact us through the support page with your order reference and we will sort it out.

Ready for your next trip?

Choose a destination, pay once and install in two minutes.

Browse eSIM plans

Refunds on unused eSIMs · Works on iPhone and Android

Frequently asked questions

Which iPhones support eSIM?
iPhone XS, XS Max, XR and all later models, including iPhone SE (2nd generation and newer). The phone must be carrier-unlocked. Some models sold in mainland China do not have eSIM.
Can I install the eSIM before I travel?
Yes, and it is the recommended way. Install on Wi-Fi at home; most plans only begin their validity when they first connect to a network at your destination.
Can I scan the QR code twice?
No. A QR code installs once. If you remove the eSIM from your phone it generally cannot be added again, so keep it installed until the plan is finished.

Get your travel eSIM

Delivered by email in minutes

Get an eSIM

Refunds on unused eSIMs · Works on iPhone and Android